Hair Dryer nanocare EH-NA0J modes, instructions, and design

Temperature is the key to achieving glossy hair. The Hot/Cold Alternating Mode automatically switches between warm air and cold air. Heating the hair with warm air smooths out any frizz, and cooling it with cold air keeps it in that state. Without the frizz, the surface of the hair is regular and reflects the light, giving a smooth and glossy finish to your hair.

[Trial method]
The hair was dried until completely dry using a dryer as one would normally do after washing it. In one case Hair Dryer nanocare with built-in Hot/Cold Rhythm Mode was used, and in the other case it was not

• Panasonic survey

• Results may vary from person to person

The Intensive Hair Tip Care Mode uses the sensor to automatically check the ambient temperature and alternates hot and cold airflow at the right intervals and air volume to provide the perfect finish for your hair tips. The weak flow is easy to direct and enables you to provide intensive care for all your hair tips.

[Trial method]
The hair tips were dried completely using a dryer as one would normally do after washing the hair. In one case Hair Dryer nanocare with built-in intensive hair tip care mode was used, and in the other case it was not

• Panasonic survey

• Results may vary from person to person

[Trial method]
Bunches of hair were finger-combed while being dried. The ratio of hair tip spread was 0.66 when dried with warm air (with airflow on “HIGH”) as compared to 0.55 when the Intensive Hair Tip Care Mode was used as far as the hair tips (for approx. 24 sec) after the hair was 90% dried with warm air (with airflow on “HIGH”)
The inverse value of the ratio of hair tip spread was calculated to give a rate of 1.3 times more sleekness

• Panasonic survey

• Results may vary from person to person

Residual moisture on the scalp surface can cause unpleasant sensations such as clamminess. Scalp Mode gently dries your scalp with pleasantly warm air at a temperature of approx. 60℃^*1.

• Use this mode when your hair is roughly 70% dry.

Skin dries out easily after a bath, but airflow containing 「nanoe MOISTURE＋」 & minerals^*3 helps protect your skin and keep it moisturised.^*2

• Keep your eyes closed while using this mode.

• Please follow your usual skincare routine, such as using a toner or emulsion.

• Directing the airflow on your face for approx. 1 min will keep your skin moisturised.

• If you select “SKIN” while the airflow is set at “HIGH” or “MEDIUM”, the airflow setting will switch to “LOW”.

Dry your hair in this order: roots, main body of hair, then hair tips. The idea is to keep the dryer about 10 cm from your hair and move it slowly. Dry your hair thoroughly until there are no damp sections remaining.

When your hair is about 90% dry, select “Hot/Cold Mark (Arrow)” with the air heat switching button.
Divide your hair into roughly four sections and direct Hot/Cold airflow two or three times to each place while finger-combing to keep the hair taut. The trick is to finish by directing Hot/Cold airflow onto your hair from your scalp down towards your hair tips.

Select “LOW” with the airflow switching button and “Hot/Cold Mark (Arrow)” with the air heat switching button.
Hold the dryer closer to your hair (about 5 cm) and direct the airflow to both sides of the hair tips while finger-combing them to neaten them. This will make your hair sleek and glossy right down to the tips.

The EH-NA0J compared with the EH-NA0G

As part of our environmental efforts, we have redesigned the packaging for our popular nano care hair dryers.
The packaging and wrapping materials are made using 95%^*5 less plastic, cushioning materials made from pulp have been adopted, and a paper-like texture has been incorporated into the design.